Tips for an optimal use of the alkus welding device ECO

 

At alkus AG, we pride ourselves on delivering high-quality, high-performance welding devices. To help you make the most of your ECO welding device, we are excited to share some invaluable tips for optimal use and maintenance. Let's dive in and ensure your device stays in prime condition! 

Avoid common mistakes and extend your device's lifespan with these simple steps:

• Set the correct temperature: always ensure your device is set to the correct temperature (look for the red mark). This is crucial for achieving the best welding results.
• Adequate heating phase: allow your device to heat up for at least 10 minutes. In colder environments, give it a bit more time to reach the optimal temperature. Patience pays off!
• Remove welding material: after you're done welding, don't forget to remove the cooled welding material from the welding shoe. This keeps your device clean and ready for the next use.
• Observe cooling phase: post-use, let your device cool down for at least 10 minutes with the temperature turned off. This cooling period helps prevent unnecessary wear and tear.

By following these tips, you can maximize the efficiency and lifespan of your ECO welding device.